Control Simulation

The third and final tab, “Control”, is designed to facilitate issuing commands from the IR transceiver after you’ve configured and verified each button.

Buttons will be grayed out until after they have been configured and verified on the “Trainer” tab. Once completed, you can use the buttons in order to issue the corresponding commands. This capability is useful for checking a given IR transceiver position in front of a corresponding STB. It is also useful to check for commands that leak and affect other STBs.

*In addition, there is a numeric field with a <Dial> button capability. You may use this field to issue tuning requests in the same way that the RPM issue them, such as for example, to tune to channel 45, enter “45” in the numeric field and click the Dial button. The IR transceiver will issue the appropriate sequence of commands needed to dial channel 45, including settings from the “Advanced” tab such as inter-command delay and “leading-zeros”…