STB remote control

When an encoder is connected to a STB the STB is typically set statically to a particular dial number (service). This enables MIS to record the channel 24/7 for subsequent playback and analysis. Optionally an encoder may be configured for STB remote control emulation. In that case MIS uses an USB IR emitter to emulate STB remote control commands. Each Encoder/STB pair configured in this fashion needs a dedicated USB IR remote controller. Position the IR emitter so it is seen by the STB IR receiver but not other STBs in the rack. The emitter is located inside the controller behind an IR transparent window. Optionally a cabled IR emitter may be used.

This option allows users to manually interact with the STB or create a schedule to automate channel switching and program capture.

Figure: USB IR remote control