Configure Notification

From the Listener tab you can configure enabling or disabling of notifications - sending SNMP traps and emails.

Figure: Listener Tab

You can set your parameters according to the table below:

Table: Notification Parameters

Send traps parameter	True/False
Send emails parameter	True/False

When both “Send traps” and “Send emails” parameters are enabled, upon detecting a fault the system will respond as per the table below.

Table: Observer Actions

Observer Detects	Observer Action
A: Fault detected	SET Alarm (SNMP trap and email) are sent
B: Fault persist	Quiet
C: Fault persist	Quiet
D: Fault is cleared	Clear Alarm (SNMP trap and email) are sent